+- Softwarez.Info - Software's World! (https://softwarez.info)
+-- Forum: Software Zone (https://softwarez.info/Forum-Software-Zone)
+--- Forum: Windows Applications (https://softwarez.info/Forum-Windows-Applications)
+--- Thread: Gowin MCU Designer 1.2 (x64) (/Thread-Gowin-MCU-Designer-1-2-x64--190797)
Gowin MCU Designer 1.2 (x64) - Farid - 10-14-2023
![[Image: P8JyJJ.l7bva4ipm1y8.jpg]](https://i.im.ge/2023/10/14/P8JyJJ.l7bva4ipm1y8.jpg)
Gowin MCU Designer 1.2 (x64) | 950.76 MB |
Gowin MCU Designer is an Eclipse-based development environment similar to Keil MDK. It is a system for developing and debugging applications based on software and hardware processor IP cores for FPGAs and SoCs from Gowin Semiconductor Corporation. It has an English-language interface and supports writing source codes for programs in C/C++.
Debugging of firmware code is carried out using third-party hardware debuggers connected to the target FPGA/SoC via the JTAG interface.
System requirements
Windows 7, 8, 8.1, 10, 11 (64-bit)
RAM: 3 GB
Volume hard disk for full installation ~ 5 GB.
What News?
Official site does not provide any info about changes in this version.
------------------------------------*****------------------------------------
Gowin MCU Designer 1.2 (x64) (950.76 MB)
NitroFlare Link(s)
RapidGator Link(s)