+- Softwarez.Info - Software's World! (https://softwarez.info)
+-- Forum: Software Zone (https://softwarez.info/Forum-Software-Zone)
+--- Forum: Windows Applications (https://softwarez.info/Forum-Windows-Applications)
+--- Thread: Gowin MCU Designer 1.2 (x64) (/Thread-Gowin-MCU-Designer-1-2-x64--235766)
Gowin MCU Designer 1.2 (x64) - jannat - 11-27-2023
[center]
![[Image: 389915474_9iib2qk7wqy9.jpg]](https://img90.pixhost.to/images/135/389915474_9iib2qk7wqy9.jpg)
Gowin MCU Designer 1.2 (x64) | Size: 950.76 MB
Language: English
[/center]
[center]
Gowin MCU Designer is an Eclipse-based development environment similar to Keil MDK. It is a system for developing and debugging applications based on software and hardware processor IP cores for FPGAs and SoCs from Gowin Semiconductor Corporation. It has an English-language interface and supports writing source codes for programs in C/C++.
Debugging of firmware code is carried out using third-party hardware debuggers connected to the target FPGA/SoC via the JTAG interface.
System requirements
Windows 7, 8, 8.1, 10, 11 (64-bit)
RAM: 3 GB
Volume hard disk for full installation ~ 5 GB.
What News?
Official site does not provide any info about changes in this version.
Say "Thank You"
HOMEPAGE:
Download Links
Rapidgator
Nitroflare
[/center]